The production method of LED BOBO balloons.

Production process

1. First, gently stretch the ball along the edge to allow the material to fully stretch to improve toughness.

2. Then use an air pump or helium tank to inflate to 90% full (to avoid over-expansion and rupture). At this time, the balloon is full and round. If you need to add personalization, you can put sequins, feathers and other decorations into the ball at this step, and finally tie a knot at the inflation port to prevent leakage.

3. Pass the 3m long LED light line from one end of the 70cm long pole (stick) and out from the other end, ensuring that the light line falls naturally without entanglement. Then align the battery box (or colored handle) with the end of the long pole and fix it with waterproof tape (to avoid falling off). At this time, the other end of the light line extends naturally to prepare for the subsequent wrapping of the balloon.

3. Pass the bottom of the tied ball through the 6cm cup base (cup), let the knot get stuck on the inside of the base, and then tighten the base and the top of the long pole (or buckle to fix) to make the balloon and the pole holder a stable whole. Finally, wrap the extended LED light wire evenly around the outside of the balloon (either in a spiral or a ring shape), make sure the light beads fit the ball body, turn on the switch to test the lighting effect, and a complete set of LED pop balls is ready.